Forums/
Deco
2021-01-14 16:46:55
@wifinovice You can have the Deco used the same SSID you have, but note that having the same name does not mean everything will be mesh. When you are around the Deco units, the nodes will recommend...
0HELPFULS
Forums/
Deco
2021-01-14 16:41:12
@JohannH You could possibly try going here: https://global.sitesafety.trendmicro.com/ That is what powers the site blocking feature so you can enter that site, and see about requesting to reclassify...
0HELPFULS
Forums/
Deco
2021-01-14 16:38:16
@MummaJ1. Your Deco will be fine and boot up again without needing to configure again. Should the main Deco not have internet after booting up (red LED), I would just reboot only the internet modem,...
0HELPFULS
Forums/
Powerline Adapters
2021-01-14 16:36:57
@Gewitty The TL-PA powerline adapters do not have a web interface. Only if you had a TL-WPA like the TL-WPA4220 that broadcasts a wireless signal will have a web interface. All the wired-only...
0HELPFULS
Forums/
Deco
2021-01-14 16:09:10
@MKFlyers2K I followed up with support and they did mention the Deco X90/X5700 does have 160 MHz support. So when you connect your wireless card to that, you should see the link speed you do with the...
0HELPFULS
Forums/
Kasa Smart Plugs
2021-01-14 00:10:40
@Mwill You would go off of what the label on the device shows. I believe the v1 mentioned 12 amps. If you are close to going over the recommended amperage that might be risky. Should the heater ever...
0HELPFULS