Forums/
Deco
2020-09-19 00:12:31
@Ralphie I got two of the Insteon (Foscam) cameras working. Instead of typing in the SSID, I clicked on the one I wanted in the camera configuration tool. I should have the switch by Monday,...
0HELPFULS
Forums/
Deco
2020-09-08 17:38:28
@Tony No it did not.. I have everything connected to a new SSID/Password except for three Insteon (Foscam) cameras. Any ideas for those? Thanks in advance
0HELPFULS
Forums/
Deco
2020-09-08 17:36:57
@Tony I have the Deco M5. Is there a firmware version for that? Is there any downsides to using that? How do I go about loading that firmware? Thanks for the assistance..
0HELPFULS
Forums/
Deco
2020-09-07 19:53:54
@Ralphie Good News.. I kind of followed the advice from this thread. I setup the Deco in AP mode, created a new SSID/password and was able to move everything but my 3 Insteon (Foscam) cameras. Has...
0HELPFULS
Forums/
Deco
2020-09-07 19:52:37
@Ralphie Good News.. I kind of followed the advice from the other thread. I setup the Deco in AP mode, created a new SSID/password and was able to move everything but my 3 Insteon (Foscam) cameras....
0HELPFULS
Forums/
Deco
2020-09-07 00:35:15
@Wizard99 I set up the Deco as an access point off my old WiFi and then set up the Deco with a new SSID and password. I will then migrate everything over and then remove the old WiFi, hopefully... So...
0HELPFULS