Forums/
Deco
2021-03-24 22:04:04
@myrlin Correct, you would use a network switch to connect to one of the ports of the Deco, from there you can wire any other device to the switch. We have found some D-Link switches have issues...
0HELPFULS
Forums/
Deco
2021-03-24 21:57:33
@kunatir If you want everything to be one network, set the S4 into access point mode. This loses the router features of the S4, but you have your one network. You can leave the S4 in router mode if...
0HELPFULS
Forums/
Deco
2021-03-24 21:53:22
@nameless 1. You need to use the upgrade utility for your V2 units to get them past 1.2.x: https://www.tp-link.com/support/download/deco-m9-plus/v2/#Utility Download the latest firmware release, then...
0HELPFULS
Forums/
Wi-Fi Routers
2021-03-24 21:22:03
@k00lrunningz Your AT&T device is a modem and router so if you connect the Archer A7 (assuming you have that) to the AT&T it will get a local IP of whatever the AT&T gives out. I am not sure what...
0HELPFULS
Forums/
Adapters
2021-03-24 21:17:55
@DLTemple If you were to swap the T2U adapters and the issue stayed on the computer, then likely is something in the computer like you mentioned. I'm thinking you can try reinstalling your USB...
0HELPFULS
Forums/
Access Points
2021-03-24 21:02:10
@HarleyRaider903 Here is an article about connecting two points: https://www.tp-link.com/us/support/faq/1226/ In this case, you would set up the CPE as an Access Point. The next potential issue may...
0HELPFULS