Forums/
Deco
2021-08-24 06:42:03
@Mordechai01 Hi, Thanks for the feedback. Currently, if only leaving the previous two X90 packs, would the disconnection improve a little bit? Were most of the unstable devices connected to the...
0HELPFULS
Forums/
Deco
2021-08-24 06:24:13
@JLSymHome Hi, currently, this feature is not supported. But I think you could consider purchasing a smart plug and connect the streaming device to the smart plug. Then set up the power schedule for...
0HELPFULS
Forums/
Deco
2021-08-24 06:19:31
Re:Cant connect aux. mesh M5 units to Main M5 Unit hard-wire connected to Router via ethernet cable.
@Deacon_3 Hi, what are the LED on the satellite Deco, red or blinking blue? When you changed the new router, did you reset the main Deco and set it up again with the new router, or just unplug it...
0HELPFULS
Forums/
Deco
2021-08-24 06:08:41
@Ke3ee Hi, Did you mean after switching Deco into access point mode, now the speed via all Deco units could reach 700m/s? When it was on the wireless router mode, all of them can’t get over 300m/s...
0HELPFULS
Forums/
Deco
2021-08-23 01:54:15
@gnosticeye Thanks a lot for sharing. It would be very helpful for us.
0HELPFULS
Forums/
Deco
2021-08-19 03:47:09
@Grumz Hi, You could have a look at this link: Why my clients don't roam/connect to the nearest Deco node? Here are some suggestions for you: 1. Put the satellite Deco next to the clients. 2. Power...
0HELPFULS