Blue Blinking light
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Why does the blue light on the Deco M5 Mesh router keep blinking on my third unit after completing setup?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
If the Deco blinks blue or pulses blue then it is ready for setup. So if you just finished setup, something may be wrong. After setup, the Deco should be solid green.
If the Deco app still does not show that node in questions, reset it by holding the reset button for 1 second, then move it near the main Deco, then set it up again.
- Copy Link
- Report Inappropriate Content
@donbilla I have the same issue, after reset the m5 , and re-setup successfully as a satellite with the app (by putting it next to the main deco) but it's still flashing blue led
- Copy Link
- Report Inappropriate Content
Go into the "more" section of the Deco app and update the firmware you may have an older version. Once that is done, hold the reset button again, and then add it.
- Copy Link
- Report Inappropriate Content
@Tony I have already exchange the other delcos but the problem still exists, now for 24 hours.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 13
Replies: 0
Voters 0
No one has voted for it yet.