Home Network Community > Wi-Fi Routers > Archer AC1200 X3 on home network as Access Point - Firmware Update
< Wi-Fi Routers

Archer AC1200 X3 on home network as Access Point - Firmware Update

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Archer AC1200 X3 on home network as Access Point - Firmware Update

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Archer AC1200 X3 on home network as Access Point - Firmware Update
Archer AC1200 X3 on home network as Access Point - Firmware Update
2021-01-26 16:50:45 - last edited 2021-01-26 16:51:45
Model: Archer A6  
Hardware Version: V2
Firmware Version: 1.1.7 Build 20201010 rel.49458(5553)

Hello - currently have three A6's setup as access points via ethernet cables to a TP-link switch. I've just setup the third and configured as an access point...and was then prompted for firmware update.

 

SSID's and passwords are the same for all devices.

Question - do I need to manually update each access point periodically or is this automatically done?

 

Thanks.

  0      
 
  0      
 
#1
Options
1 Reply
Re:Archer AC1200 X3 on home network as Access Point - Firmware Update
2021-01-28 18:05:05

@GhengisTom 

 

The router can update itself, but you need to initiate it. Use the Tether app to log into each AP unit, and then tell it to begin the update.

 

Case 2: https://www.tp-link.com/us/support/faq/2139/

  0  
  0  
#3
Options

Information

Helpful: 0

Views: 8

Replies: 0

About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.