Updated; A couple of things happened recently 1) People upgraded to IOS14 2) I updated the controller and devices to the latest firmware (new interface) Results IOS Clients behaving funny; keep droppi

Just updated the OC200 to the new v1.7 firmware Before doing so, it warned me to check compatibility, which i did. I have 3x EAP245 and 1x EAP225-Outdoor. It wanted firmware version: EAP245_V3 2.20.0

Seems like the 225 outdoor AP and ios14 don't like each other, I can't get any ios14 devices to stay connected. They connect and then immediately disconnect. I've tried restarting the devices, forgett

I have 3 of these AP's and i've attempted to configure them on seperate channels for the 80mhz width option. Therefore, channels configured are (I'm in UK) Floor 1: 36 Floor 2: 100 Floor 3: 52 I have

Hello, I have two problems with this AP and I hope you can assist me a little bit. .) I can't choose a channel higher than 112. I have the option to chose from 36 - 128 but whenever I choose something

As the title says, is it ok to mount this upside down? The way this will be wired, with cat6, the connector is underneath the unit and the wire will come from above. The question is regards to the omn