Yes, you're right. I was under impression that the web UI of TL-SG108E is a subset of the web UI of other switches such as the TL-SG2008 for example, which lets one indeed select VLAN 1 (the...

ea4fyh wrote At first I need two cables for connect the router to switch, because It`s not possible conect with a trunk with only one wire. See this post for how to create a trunk in DD-WRT and...

PeterL. wrote Maybe someone has some spare time to give it a shot ... Nonetheless I would prefer to get the API of the EAPs, so I could integrate the EAPs into our own hotspot software. We even do...

M@rius wrote Ok I have sorted this setting also, on your youtube demo of cpr510 you recommend scanning the frequency for quality, in the graphic are 3 lines yellow, red and blue, red an yellow are...

JensKofoed wrote How should the switch be configured to allow tagged packets from the access point to enter at port 2 and exits at port 1, and the replay going back Just enable 802.1Q VLAN mode, add...

lexxai wrote Forgot about it device until new firmware will be. I have same problem, and I use it switch just as unmanaged. I don't understand why TP-Link uses a valid VLAN ID 1 for a default VLAN...