Set both switches to factory defaults. Then assign each switch a unique IP before connecting them.

AINEMORF wrote In other way do I have a change to see for a SINGLE transfer a speed > 1 Gbit/s? (working on configuration of my switch or on configuration of my pci lan quad adapter) IMHO this...

bobkaron wrote How do you get around this problem? You can set the RSSI Threshold of the EAP225 to force a disconnect if signal is too low. But the client device always decides for itself to which AP...

tx350z wrote In my case Easy Smart switches are being used so no inter-VLAN routing can be done by the switches. I agree that you can multi-home a net adapter which just leads to even greater...

Finally TP-Link made the TL-ANT2410MO omnidirectional antenna for WBS210 available in the EU. It's a 2x2 MIMO (dual polarized) antenna with 10 dBi antenna gain and a mounting slot for the WBS210....

Set channel width to 20 Mhz. Increase TX power on both CPEs to maximum, not 0. Set WDS to Auto, not Disabled. Set Encryption on both CPEs either to Auto or to AES, but not to AES on one CPE and Auto...