@binio how about enable the "IPv4 routing" option, and then check the firmware version is up to date or not, not pretty after reset can make it work or not. By default, the VLAN interface can talk to...

@Diovani hi there, different company has different VLAN mechanism, this is the old and new mechanism for tplink, it is advised to contact ubiquitin to check.

@userNAC Hi there. 1. All the setup need to be done on the OC200, after configure the setting on OC200, the OC200 will send all the setting to the router, switch and EAP. The requirement for the...

@Fitz876 How about uprading the firmware version into 1.2.4 Build 20201120? It is avised to contact the support team, and you can tell them what EAP's model you have and what is the printer's model.

@Spike60 Hi there, you can log in the management page of the Client to check "Status--Radio Status--Tx Rate/Rx Rate", this is to make sure that the Client is connecting to the AP. There has a pretty...

@Terence19721 Hi for the roaming you need to use the Controller Software and keep the PC with that Software running all the time. Also, you can buy a hardware controller OC200, this can replace the...