TonyOffline
Following: 0Followers: 54
Forums/ Range Extenders
2021-04-06 21:27:11
Re:RE300 and FIOS router
@TFX The RE300 has OneMesh capabilities, but it requires a TP-Link OneMesh router. In your case, if you set up the RE300 with the Verizon device it will work as a typical range extender. As far as...
2HELPFULS
Forums/ Deco
2021-04-06 20:54:34
Re:M9plus / P9 mesh configuration question
@DKS736 You would want the M9 being the main router. Another setup can be using powerline adapters so you can have the TL-PA7010PKIT, one wired to the main or satellite Deco, and the other wired to...
0HELPFULS
Forums/ Adapters
2021-04-06 18:52:41
Re:SLOW SPEEDS on Archer T2U AC600 (US) Ver3.0
@Zash The speeds being "up to" is the key when judging the performance. The real-world speed you finally get can be determined from a variety of factors. Sometimes it can be the computer, the port,...
0HELPFULS
Forums/ Deco
2021-04-06 18:16:23
Re:Deco M5 Guest Network
@Slog If the Deco is set in AP Mode then it doesn't have any control over the routing so I would start with what the main Deco is wired to. You could also disconnect the Deco and plug that same...
0HELPFULS
Forums/ Cable Modem&Routers
2021-04-06 18:07:30
Re:MOCA 2.5
@Ziure916 I believe you may be talking about our cable modem/routers such as the Archer CR700? In any case, no they do not support MoCA.
0HELPFULS
Forums/ Range Extenders
2021-04-06 17:46:02
Re:Factory reset on Cpe210 problems! Help new to wifi extenders.
@blackattack3 Wire your computer directly to the CPE, and assign a static IP to the computer such as: IP: 192.168.0.10 Subnet: 255.255.255.0 Once connected to the CPE, open your browser and try the...
0HELPFULS
1394041...