110 and 130 Bulbs dropping / losing connnection

Hardware Version :
Firmware Version :
ISP :
I have three LB130s and two LB110 bulbs set up in hard-wired light fixtures, connected via a Netgear Nighthawk AC1900 running current firmware. I am having constant disconnect problems with both bulb models, with disconnects sometimes happening within just a few minutes. The only way to bring the bulbs back online is to remove and reapply power; they'll power on (and light up), within a minute or so they'll be back online.
I've spent the better part of a week trying different things to attempt to keep the devices online, all without success:
[*]Verified firmware is up to do using Kasa.
[*]Confirmed firewall rules allow outbound access.
[*]Set 2.4GHz access point to "failsafe" settings (RTS/CTS settings, Fragmentation)
[*]Changed 2.4GHz wireless to different channels (1, 3, 6, 7, 9, 11) to attempt to eliminate the possibility of interference.
[*]Relocated my wireless AP to ensure clear line-of-sight to all bulbs.
[*]Set DHCP reservations for the bulbs.
Symptoms:
Devices appear offline (grayed out) in Kasa.
[*]Bulbs remain in operating state when they lose their connection (if on, they stay on; if off, they stay off)
[*]Unable to control devices in Kasa - device offline or out of range error.
[*]Bulbs do not respond to 'ping.'
[*]Bulbs come online - every time - perfectly after power cycle.
My feeling is that the bulbs are either going to sleep or otherwise failing a "keep-alive." I'm running a constant 'ping' from my desktop to see if that helps keep the bulbs online. Anyone seen this? Anyone have a solution? (TP-Link - perhaps a firmware problem?)
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
I also a lot of time facing this problem but my brother has an engineer so solve this issue at this time.
- Copy Link
- Report Inappropriate Content
I also a lot of time facing this problem but after some time this issue solve autometic.
- Copy Link
- Report Inappropriate Content
Very informative post. Keep up the good work. I would really look forward to your other posts. |
- Copy Link
- Report Inappropriate Content
Very informative and impressive post you have written
- Copy Link
- Report Inappropriate Content
I had very similar problems. Tried everything . Was ready to throw it all out and start over. Eventually I setup all the devices on my "guest" network provided by my router. Don't know why but the devices have worked perfectly since. It has been months now and everything is stable. Good luck.
- Copy Link
- Report Inappropriate Content
I am consuming continuous separate glitches with both bulb replicas, with separates occasionally trendy within just a few notes. The only way to transport the corms back online is to eliminate and reapply control; they'll control on (and light up), inside a minute or so they'll be spinal connected.I am consuming continuous separate glitches with both bulb replicas, with separates occasionally trendy within just a few notes. The only way to transport the corms back online is to eliminate and reapply control; they'll control on (and light up), inside a minute or so they'll be spinal connected.
- Copy Link
- Report Inappropriate Content
@kalmairn it is really a Very <a href="https://newshubfeed.com">informative</a> and impressive post you have written
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content

Information
Helpful: 0
Views: 70
Replies: 0
Voters 1
