Ah, I see the problem. Omada Controller 3.0.2 not only re-configures the EAP, but resets its software settings in the database for the IP of the EAP to factory defaults as soon as it discovers the...

jonas wrote Hi R1D2, Thank you for the suggestion. EAP115-Wall(EU) is still a selling model of EAP products, but please remember EAP115-Wall just have EU version.(Because it only support 86mm and EU...

Pascal wrote I agree with R1D2, the actual procedure with the archives is not friendly admin management and we need to go there periodically to make free the ram from the controler.It is really...

aFunkyBass wrote As for the switch you suggested, I guess that 4 POE ports aren't enough as I have at least 6 POE powered access point. Do you think that adding a multi port passive POE injector on...

Manfred wrote Hey R1D2, I share your objection about dialogues but in this particular case you probably agree that the 2 buttons "REboot" and "REset" in the UI are VERY close to each other....

puntjuh wrote The problem is that i cannot pre-provision it... The configuration tab does not become available until after i have adopted the EAP and goes into the provisioning phase, in which state...