Co0LD0wN wrote i used the same ip and subnet there.. look at the second pic.. EAP's static IP is 192.168.9.1, subnet is 192.168.9.0/24. Default gateway for the EAP is 192.168.33.1, subnet is...

Ek9max wrote If left in auto mode will the software select a good set of channels? I have 6 eap in my house. It usually does so. I don't know how big your house is, but you could further improve...

Mtnman1000 wrote Thanks R1D2, I will give that a try in the AM and update the post. I really appreciate the help you are offering. I do the same in other forums and am always glad to help. Pay it...

First, set AP Client Router mode. Note that you will temporarily need a wired connection to the CPE for initial setup: Next, enter SSID and key of the RV park's WiFi (Page »Wireless«): Check WAN...

You're welcome. Remember that CPE210 has two directional antennas with a beam width of 65º, not omnidirectional antennas. This means the best signal strength is just inside this angle.

Mtnman1000 wrote What would be the correct mode to use in my case in order to use a Wireless router inside my RV using the CPE210 to RV Parks wireless AP? It would be "AP Client Router" mode. The...