jhayes wrote Does the 5 ghz one give off a better range? Depends on the situation in your area. Often the 2.4 GHz band is overcrowded. For real-world speeds of a CPE510 see this story and compare...

Lessersol wrote So keep the DHCP server on at the router level but disable at the switch? Depends on your setup. If your network(s) should use an isolated transfer network to the router just for...

@woodgee, it's just a guess. If you have no optical attenuators at hand an old trick to test whether a received signal is too strong is to wrap the cable around a pencil until the desired level of...

columcille wrote @columcille Thanks for that. could i connect from router with ethernet cable to the poe of the eap110 Yes, of course you can use an Ethernet cable from the EAP's PoE injector (LAN...

LWL Duplex OM2 (Multimode, 50/125) - 0,5m Just a guess: the sender's light signal could override the receiver's sensitivity on a 0.5m fiber cable. Usually an optical attenuater is needed in such...

GRX wrote 1. I connected the AP near the router. In this case the Omada Contreller sees it and it adopts it smoothly. I then went into the Asus router interface and assigned an IP adress...