Marketroid wrote So to make sure I understand, any transmission from any neighboring device, connected to other APs that use the same WiFi channel, would register as Rx ? And Tx, in the case of no or...

Marketroid wrote I would expect it to register as interference and not utilization No. Interferences are WiFi frames which got corrupted due to collisions, for example if two devices send data at the...

JCDave wrote I just didn't know if it was possible to replicate that same configuration more than once within a given LAN. Why not? It's just a plain AP of which you can have plenty in the same LAN,...

Trifsterpsu wrote I just read some more about DFS channels. Now I understand better. The AP does a channel availability check on power up if those channels are available. If available then the AP...

@JCDave for a PtP link you cannot use a mesh with two root APs. But you could use a root AP ↔ mesh AP 1st hop ↔ mesh AP 2nd hop ↔ mesh AP 3rd hop setup. Unlike in other mesh concepts, in Omada mesh...

Did you change the default IP address of the two CPEs? If you did already, set the wireless network to 802.11n-only mode, channel width to 20 MHz and distance to either Auto or the actual distance....