@jbaptista, I suggest to contact TP-Link support directly through your country's TP-Link website.

Deadmeat wrote Any suggestions on a possible restore process? Otherwise I'm just gonna return it to Amazon and get a replacement. The only way I know how to re-install the official firmware is...

Ok, a last try to explain real-world WiFi behavior. Test setup: MacBookPro, EAP225 AP, 802.11ac-only WiFi mode, 80 MHz channel width, Gigabit interface, ISP speed 400/20 Mbps, speedtest:...

Falrath41 wrote The story you referenced also mentions that the speed was limited to the ethernet port speed of only 100 and they hit approximately 115-130 mbps which is less than half of the speeds...

Hi @JulioSilva, you can use link aggregation to group ports into a link aggregation group (LAG), but only if your router supports this, too. See section »Configuring LAG« in the User Guide for...

Hi @jbaptista, if the switch changes its IP after a reboot/power failure, make sure to save the config (see the »Save« button on the top right side in the new or bottom left menu item in the old web...