Meshing is currently supported by EAP225 and EAP225-Outdoor only. It has been announced in a future firmware version for EAP245, too. Note that all EAPs you want to mesh need to support meshing, so...

ASCII wrote I was wondering if the EAP245v3 can be used as Root AP in a mesh network? AFAIK the EAP245 still does not support meshing. But even if will support meshing in a future firmware version...

@PC-Dude, if the electronic parts of your CPEs are made out of plastic, you should apply for a nobel prize in physics. For all others using standard electronic components made out of silicium which...

@fdb in Repeater mode the CPE uses the same SSID it is connecting to. In Bridge mode the CPE can use different SSIDs: However, as you can see in the Operation Modes diagrams, Repeater and Bridge...

The switch comes with static IP 192.168.0.1 by default (as any other managed switch, too). You need to assign it a free (unused) IP from your network before connecting it to a router. See the...

@NikolayStoyanov, did you set the IP address of the switch? Sounds to me as if the switch and the router (or another device in your network) use the same IP address.