CoKro wrote So a few things jump out at me. This firmware is a few versions old. Why doesn't the newer firmware work right? And second, in this case, port 9 should have been tagged, not untagged,...

fdb wrote But since I have you... a bit more info? Two CPE's in the middle is quite doable. But how would they be configured? The one pointing at the source would be a client (right?), cabled to the...

@fdb, it should point to the source CPE and to the destination CPE which is possible only if both are inside the 65º angle of a CPE's antenna beam width. However, you will run into the Hidden Node...

heiko2 wrote i have to connect the eap225-outdoor to a cisco ap as a client/bridge to bring devices via LAN to the network. is this also possible? No, EAPs can't run in client mode. You could use a...

Aspage wrote Your explanation is very clear, although I'm a bit confused why I would need to set a PVID, if I already set an untagged VLAN for a port. But if that's what it takes, I'll manage, of...

rockin wrote I came here first to say thanks! I got this running on a Raspberry Pi, which beats waiting for a controller in Windows! I also wanted to share that I was able to get this up and running...