@exzant, the output from ping says it all: Again: connect the CPE directly to the PC. Don't connect the CPE to you network unless its IP has been set up to fit into your network.

clarence1379 wrote sir i think LAN takes time to kick in compair to WLAN thats my intial thought after seeing this. Wrong. The X axis counts the time from the beginning of selection of the interface...

@grayb, waht do you mean? The TL-SG1008P? It's not outdoor-capable AFAIK. I can only speak from my experience and I would not try to connect modern CCTV cams wirelessly, but that's only my personal...

@grayb, yes but remember that the CPE itself runs at 24 volts (»passive PoE«), while the PoE switches provide 48 volts (PoE 802.3af/at). I use UBNT EP-R6 outdoor switch with 24 volts PoE output (it's...

Hi @Pascal, today I updated an EAP225 to firmware 2.7.0 and did run tests. Could not reproduce the effect you are seeing of absent clients not listed as disconnected. Checked this with two iPhones, a...

Hi @Snc, the step-by-step instructions are in post #1 already, but overall setup varies slightly on different Java environments used in different Raspbian versions. Maybe you have a friend with a bit...