@noel_avat, EAPs don't use 30-30-30-reset. To reset an EAP, press the RESET button for 5 to 7 seconds until LEDs start to blink. Afterwards, the EAP uses factory default settings (DHCP with fall-back...

@pgcudahy, EAPs are just access points, not routers, so no, they don't support wireguard which operates at layer 3 and thus needs routing. You could connect EAPs to your RasPi's subnet used as a VPN....

@steve_togo, TP-Link decided to not add DFS for the US version (see this post here). They never promised to add DFS for the US version. DFS for the EU version of EAP225 has been added to allow using...

RAlkaabi wrote I have hard reset the EAP, and still no luck - the name of the SSID is back to default, however, no mean of ability to interact with it through Web UI. If the factory reset did work by...

@DiscoUnixg, you did set up two networks (VLAN ID 1 and ID 30), but your router on untagged port 8 is either a member of VLAN 1 only (if the port's PVID is 1) or a member of VLAN 30 only (if the...

@Ecg, CPEs are for directional links, not for omnidirectional WiFi coverage. That's why I recommended to use an EAP225-Outdoor at the garage for local WLAN distribution (see first and third...