@PaulWSR, hard-reset the CPE to factory defaults (see Installation Guide for more info), connect it to your MacBook, set your MacBook to static IP 192.168.0.10, address http://192.168.0.254/. BTW:...

@cgmedina, disable MAXtream if this is a PtP link, change WiFi mode to 802.11n only, change channel to »Auto«, make sure antennas are properly aligned (use the »Antenna Alignment« tool). Consider use...

@Argy_kap, »losing the link« is a bit too vague to be able to help. Please show both CPE's settings and their link statistics when the AP and the client CPE are connected. What are the values for...

samc2696 wrote Hi, okay so it's on the ground floor and wall mounted above a door that's basically in the centre of the ground floor. When mounting EAPs on walls you need to take their coverage into...

dkuchta5 wrote Note that in your first diagram, which I've seen in the manual, it shows "User Network" and has wifi symbols indicating a local connection to wifi devices. This is what I was finding...

dkuchta5 wrote According to the manual, the "AP Client Router" mode *does* allow you to use both wired and wifi ethernet at the remote location. Any operation mode does allow to use wired and...