Home Network Community > Wi-Fi Routers > Archer C6 V3.2 all lights on and can't access Web ui
< Wi-Fi Routers

Archer C6 V3.2 all lights on and can't access Web ui

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Archer C6 V3.2 all lights on and can't access Web ui

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Archer C6 V3.2 all lights on and can't access Web ui
Archer C6 V3.2 all lights on and can't access Web ui
2021-07-31 18:15:36
Model: Archer C6  
Hardware Version: V3
Firmware Version: US

I was trying to update the firmware of the router. I flashed the EU version instead of US one. How to recover it.

 

 

 

 

Tp Link Archer C6 V3.2

  0      
 
  0      
 
#1
Options
1 Reply
Re:Archer C6 V3.2 all lights on and can't access Web ui
2021-08-01 20:39:17 - last edited 2021-08-01 22:07:21

@Saad.. 

 

It's best to take a look at the bottom sticker of the device to determine the HW version and FW region to be sure before upgrading the device FW - here' s a guide.

For some reason the US firmware for C6 v3 is unavailable at the moment on the support portal - you can download it from here.

How did you upgrade the FW ? Through the Web management interface or by TFTP method ?

If you used the TFTP method, then use it again with the correct FW.

  0  
  0  
#2
Options

Information

Helpful: 0

Views: 15

Replies: 0

About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.