Hello, I have a setup with a TL-ER6120 router with 2 WAN used in load balacing and an IPSEC LAN-to-LAN tunnel enabled on the WAN1 interface. On the local LAN in am using addressing 192.168.1.0/24. Usi

Hi, I use the MC210CS as a galvanic isolated monitoring solution. However, a lot of packets are not visible when I use WireShark to monitor the network. I suspect that the media converter is acting as

we want to move to the above tplink switches, currently they have dlink with sfp adapters for their fiber I wanted to add pictures of the current fiber connector and the current adpater to find the co

I have a new R600VPN and two Netgear cable modems. The management ports of the cable modems are hard coded to the ip address of 192.168.0.100. Each are connected to a WAN port and all normal outbound

My settings Switch: DLINK DGS1510-28 (PORT 1) ---- tagged ----> T1500G-8T 2.0 (PORT 8) Net: VLAN10 - 192.168.0.0 (PORT: 8) VLAN50 - 192.168.50.0 (PORT: 1, 2) VLAN80 - 192.168.80.0 (PORT: 3) I want: 1.

Hi guys, please forgive my limited knowledge on this subject. I have setup a Load Balancer for a client and after the Load Balancer we have a Mikrotik. The Mikrotik has been setup by the client in a p