That puzzled me too. The WISP mode is also a kind of router mode, but with a wireless WAN instead of an Ethernet WAN. If WISP mode works, then router mode should work too. Did you used MAC clone when...

Adding MAC clone is not a solution for your case. In AP mode the device work as a Layer 2 switch, which means it is totally transparent and just transmitting the signal as you said. The device itself...

1. You configuration is ok. 70dB is good enough. But it would be better to configure the second TL-WA7210N as Client mode instead of bridge with AP mode. Bridge with AP mode will lower down the...

itadmin wrote I have a very similar problem with the WA-7210n in that even using them in AP mode and Bridge with AP Mode the MAC addresses do not get forwarded, and as the network access is by MAC...

Navigate to Network --> Wan settings --> Edit your PPPoE connection --> WAN Service Setup, unchecked " Enable IPV6" and ensure connection mode is Always on.

reboot the Dlink, ensure there is no IP reservations or ARP banding on the Dlink reset the WA801, reconfigure bridge with AP mode. Disable DHCP.