Should be an Access Point with built-in DHCP server enabled and set up. Give the CPE and the camera a static IP, DHCP is for the wireless clients only.

Since in repeater mode the CPE just repeats a wireless signal from another WiFi router, you only need to connect a cable from the injector's PoE (output) port to the LAN0 PoE (input) port of the CPE...

pleased wrote The only thing I can think of so far is that, when the SG108e transfers a packet to my router "across PVIDs", it does something to the packet to cause the router to send a broadcast in...

pleased wrote I think a "loop" would occur if, say, my router repeated ARP packets sent into its single LAN port out the same port. It's not doing that, is it? To answer, I would need to know little...

glasser wrote TP-Link already has a Version3 in the pipe as seen on their support site... that is if you care to debug their design by trials! TPLink routers are mostly great, unlike the chip vendor...

In port-based VLANs assigning a port into more than one VLAN usually makes this port a trunk port, so it is not an access port anymore (no matter what it's PVID is). The TP-Link example in the...