Try to find the most unused channel. Note that in n mode using OFDM modulation, the CPE will use 4 channels @20 MHz channel width, so be sure to set it to 4 channels apart of your neighbor's device...

Set the CPE210 to client mode and connect it wirelessly to the RE210 if this is already connected to your local WiFi network. Connect your CCTV cameras to the CPE210 - no router necessary. The CPE210...

Do your neighbors also use 4 watts TX power? :o Then that would pretty much explain casual drops back to 1 Mbps. :D

Beware of AP router mode: it will expose your personal network to the guest network if connected to the same router/modem.

yandoo wrote That's the firmware I have, Release 38185MAXtream: OffRegion: Test_ModeChannel: 1Width: 20/40mhzMode: B/G/N MixedMax TX Rate: 300MbpsTransmit Power: 27dbmDistance: 0.2km TX/RX rates are...

binary wrote On this VM (no Domainmember) i have configured some routing and firewall rules to prevent access to other things except EAP Controller from both VLANs. This is a professional alternative...