NeoMod wrote It's connected as a simple Access Point (PoE) trough a PoE Switch.After a lot of troubles with the Controller Software (honestly, that's a horrible piece of software) I managed to...

An additional AP is recommended since CPE510 has a directional antennas, but for typical distribution of a WiFi signal you would want to use omnidirectional antennas (and probably 2.4 GHz or a dual...

Note that the CPE220/520 models are not available in the EU according to TP-Link support - they probably have been manufactured for other countries only (e.g. Australia and the Americas). But I found...

mprell wrote How is it possible to add remote APs to the EAP controller? Use the EAP Discovery tool to adopt the remote EAPs (see the EAP support page for the EAP Discovery tool).

Great! Thanks for sharing. Settings are retained now over a reboot. Hope they will fix it in TL-SG108PE, too. Now, there is only the VLAN 1 issue left:...

spran062 wrote Look here for the solution: https://www.youtube.com/watch?v=-axa1zzbnyk[h=1][/h] US region setting actually gives you 16dBm TX power on channels 1 and 11, 20dBm at channels 2 to 10,...