Snotmann, you're right and it is even worser: TX byte count for LAN0 overflows at 2GB, while RX count for WAN7 overflows at 4GB (firmware version 2.1.6): (The small difference in the packet count is...

Tobacco wrote But in actual cases and products, this is left to vendor. I think in a later version the controller could allow you to redirect https pages too, as some other vendors have already done....

PC Action wrote Is it possible to configure the dhcp on this switch? Or is it not possible on this switch and do i have to work with a router/modem before the switch? No, the TL-SG3424 is a L2...

If you set up the EAP at home, it will use your home server's IP. If you then move it to another network, which use another IP range, it won't work. You should leave the EAPs at their defaults and...

geobikas wrote If a connection is established among those 2 AP Should i leave all than configuration as it is? I mean if a connetion is established there my home computers wil get ips through DHCP...

Oh, it's not that critical except on initial connect. A trick which worked for me, is to set the AP to fixed channel 100, reboot both devices and let the devices automatically re-sync/change channels...