Did you set factory defaults on the AC50 to ensure that it is not a config error?

See the thread below: http://forum.tp-link.com/showthread.php?104188-CPE210-510-new-firmware-2.1.11-released-today-(includes-KRACK-fix)

RTouris wrote how about changing the font size in survey, they sure are taking their sweet time with this one :/ Still waiting for this one. Also, spectrum analysis is unusable in CPE210 without a...

You need two access points CPE510, both are sending/receiving at the same time. One CPE is to be placed at your home (working in AP mode), the other one at your shop (working in client mode). You...

ve7prt wrote Except that on my switches, I can only assign 1 PVID on a tagged (trunk) port. At any rate, I left all the "trunk" ports as PVID 1, yet the VLAN traffic is flowing as it should. I guess...

Set your PC to a static IP in the 192.168.0.0 subnet to be able to access the AC50. Also, it's always best practice to connect the PC to devices directly for initial setup before deploying them into...