If you try to directly connect wireless cams to the CPE over 300m: no way. Wireless cams usually do have weak antennas only and they are not suitable to connect to any AP over 300m. To set up a...

If using EAP Controller you can disable the portal there. If using the EAP in stand-alone mode, go to the web UI of the EAP to turn it off. See the user guide for detailed information.

cpe210Broke wrote Before you sent that I had already installed v2.1.6 from the Australian cp210 page. Is that one fine? I had no problems with v2.1.6, but given the fact that 2.1.11 and 2.1.12 were...

pcoluna wrote My idea is in reception put a pole with the new TL-ANT2410MO antenna connected to an WBS210, that connects to a port in the ISP router. In every house put a pole with a CPE210 and...

newlinux wrote but perhaps the names were changed after upload? Yes, the names are being changed by the Controller.

Signal strength is o.k., but could be better on such a short distance. Try to align the CPE's front exactly to each other. You should also upgrade the firmware to 2.1.12. Download it from the german...