@EIBROG Hi there, not pretty sure you are using the controller software or not to use the VPN, there has the instruction for you to set up VPN for PPTP/ L2TP, along with the instruction on how to...

@Paul-D Not pretty sure how did you connect your device in the network, but I see that the switch is in another VLAN with subnet 192.168.1.1, the OC200 and two EAP are in VLAN10 with subnet...

@obadvw Devices other than VLAN 1 cannot obtain an IP address through DHCP and cannot access the network when using Controller to manage the router, if you want to achieve that, you need to have...

@Lagu Please try to use the Tool ”Spectrum Analysis“ to chose a clean channel and frequency. The relatively low and continuous part of the average curve indicates less radio noise.

@Stefan1977 The failover means when one WAN port fails to work then the second WAN port will take effect. This is a function in the "Link backup". But for the Deco issue, you can try to change the...

@lexam How about reboot the device and then try to adopt the device? After upgrade the firmware version, the controller software needs some time to send the adopt command and file to the router....