@Libbi66 Hi there, you just need to downgrade the firmware of EAP245 v3 from 5.0.2 into the old firmware version, then use the v3.2.10 Controller Software, and all the EAP can be managed with the...

@tintin93 I see that the value of the TxGoodPkt and RxGoodPkt is also pretty high, did the issue also happen on the TL-SG108E? How about resetting the SG116E and upgrading the firmware?

@Satran Would you please share the setting on the "Load Balancing--Basic Setting"? Did you enable the option “Bandwidth Based Balance Routing” and set up the Upstream/Downstream Bandwidth?

@JLAN_10 To make PCA and PCB have different subnet and can communicate with each other, it probably depends on how the router creates the multi-subnet. For the switch, port2 set up VLAN1 and 50,...

@nutzich Port 4 sets up as the Isolated port, and port 5 doesn't set it up. The User Guider tells me: An isolated port cannot communicate directly with any other isolated ports, while the isolated...

Ironically the room I'm most concerned about is the room that the bt router and fttp modem is in which I use as an office. If worst came to worst I could just enable the WiFi on the bt router, but...