Problem with the 1200mbps model
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Problem with the 1200mbps model
Model :
Hardware Version :
Firmware Version :
ISP :
Hey guys,I installed the 1200mbps version of the tp link powerljne yesterday. However, i ran into a problem. The connection itself seems fine, i get around 90 down 100 up, which is fine. But everytime i boot my pc i have to disconnect the ethernet cable from my pc and stick it back in. Otherwise i get an error saying the pc doea not have a valid ip configuration. I thoughg it might be the powersave mode so i disabled it. This did not fix the problem unfortunately. I am sure it has something to do with the powerlines because when i hook my pc directly into an utp port it works fine. Sorry for any grammar mistakes, English is not my native languagr. Thanks in advance!With regards,
Hardware Version :
Firmware Version :
ISP :
Hey guys,I installed the 1200mbps version of the tp link powerljne yesterday. However, i ran into a problem. The connection itself seems fine, i get around 90 down 100 up, which is fine. But everytime i boot my pc i have to disconnect the ethernet cable from my pc and stick it back in. Otherwise i get an error saying the pc doea not have a valid ip configuration. I thoughg it might be the powersave mode so i disabled it. This did not fix the problem unfortunately. I am sure it has something to do with the powerlines because when i hook my pc directly into an utp port it works fine. Sorry for any grammar mistakes, English is not my native languagr. Thanks in advance!With regards,
