jbaccrington wrote

Hi

Here's proof of plugs I have bought & tested.





So I will be seeking to return these plugs to TPLINK, its been too long to return them back to Amazon.

I was getting drop outs, and when I used the TL-PA8030P KIT AV1200 to connect another computer in another room, my internet speed was much slower.

Note: The TP-LINK TL-PA7020P plugs appear to be working fine.

tadmeister69 wrote

Hi All, I had the same problem but found out the issue so I'm just replying in case this helps anyone else.

Basically I noticed I was having issues/blips in my connectivity - sometimes just for a few seconds and sometimes for minutes at a time. Even when it was for a few seconds it was long enough to disconnect the VPN I use for work so it was annoying. At the same time the middle light would flash from green to red then back to green.

I downloaded the tp-link utility ( http://www.tp-link.com/en/download/TL-PA8030P-KIT.html#Utility) and used this to see my network. I noticed that there were between 1-3 AV500 devices that kept showing up when the connection went red and I assumed this was due to an issue with the devices/firmware, however when I tried to connect to my router I randomly noticed a load of extra devices added that weren't on my network and things I knew were on were missing! Essentially I worked out that the issue was that my neighbour has some wirless TP-Link devices (they show up as AV500) and uses a similar provider to me (BT subsidiary). His AV500 devices were patching into my network and instead of routing through the powerline my devices were going through his network (wirelessly) and out through his router which has the same stock default gateway (192.168.1.254 unsurprisingly). I didn't know this was possible when the AV1200 isn't wireless but it was definitely the issue as I've now fixed it - maybe this is a new feature on the AV1200 devices which is why people are having issues with those and not the older models? I think the different length of network outages/blips were due to it flip-flopping over or straight up having asymetric routing and losing packets.

Given the amount of people that use BT/Plusnet etc routers with the same gatewat and who don't change the network on their TP-LINK I'm sure I'm not the only person to have this issue. To find out if you have the same install the utility and look at the network tab to see if you can see more devices than you expect to see on your network. If you do then to fix the issue use the utility and connected to each AV1200 device and changed the name of the network from the stock value (HomePlugAV) to the a bespoke value. In my case as soon as this was done my neighbors AV500 devices no longer accessed my network and no longer randomly appeared; Since then I've not had a single red light or (touch wood) network issue!

Hope this helps someone else out there! :)