Configuration issues
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Configuration issues
Region : Ireland
Model : Archer C9
Hardware Version : Not Clear
Firmware Version :
ISP :
Hi all, trying to integrate 2 x new Archer C9 units into our network that previously had a standard AP for wifi users.
Our LAN subnet is 192.168.1.x and I have configured the C9 WAN interfaces as statics (192.168.1.241 and .242). Whilst I can ping those addresses from a workstation on our LAN, I cannot access via browser for admin.
As I have two C9's should I configure the LAN interfaces on different subnets i.e. 192.168.2.x and 192.168.3.x and leave DHCP as default to issue IPs on each subnet?
Thanks.
Model : Archer C9
Hardware Version : Not Clear
Firmware Version :
ISP :
Hi all, trying to integrate 2 x new Archer C9 units into our network that previously had a standard AP for wifi users.
Our LAN subnet is 192.168.1.x and I have configured the C9 WAN interfaces as statics (192.168.1.241 and .242). Whilst I can ping those addresses from a workstation on our LAN, I cannot access via browser for admin.
As I have two C9's should I configure the LAN interfaces on different subnets i.e. 192.168.2.x and 192.168.3.x and leave DHCP as default to issue IPs on each subnet?
Thanks.
