Home Network Community > DSL Modem&Routers > Help needed to connect AX3000 to vr1600v
< DSL Modem&Routers

Help needed to connect AX3000 to vr1600v

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Help needed to connect AX3000 to vr1600v

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Help needed to connect AX3000 to vr1600v
Help needed to connect AX3000 to vr1600v
2021-08-22 07:04:05
Model: Archer AX3000  
Hardware Version:
Firmware Version:

I am hoping someone can provide simple instructions to connect my newly purchased AX3000 router to my existing VR1600v modem router.

I am using wan-wan to connect them. 
The new router does not see the internet
Thanks

  0      
 
  0      
 
#1
Options
3 Reply
Re:Help needed to connect AX3000 to vr1600v
2021-08-22 10:29:45

@Dan75 

 

Try connecting VR1600v LAN1 port to AX3000 WAN port (Dynamic IP) and test.

If you are concerned about the double NAT you can put AX3000 in AP mode.

 

  0  
  0  
#2
Options
Re:Help needed to connect AX3000 to vr1600v
2021-08-22 21:19:22
Hi Terzivski Thanks. That is exactly what I found I had to do to resolve. The easy set up manual advised wan - wan connection. Ended up it wasn’t so easy for me 😀 Appreciate the advice.
  0  
  0  
#3
Options
Re:Help needed to connect AX3000 to vr1600v
2021-08-24 11:41:59

@Dan75 

HI, I am glad that the issue has been solved.

But I  am a little curious about the easy setup manual and can I have a picture of the manual you have referred to so that we could check whether there is any misleading information in case of further confusion?

Thank you very much.

  0  
  0  
#4
Options

Information

Helpful: 0

Views: 5

Replies: 0

About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.