@XxalmogxX 

Hi, I tend to think it is not related to the EU or US version.

And actually, the firmware for Deco X60 V2 is the same for the EU and US versions.

so you said that the EU and US are the same devices ? without limitation from what I know that the US is more open in the channels am I right? or in this model, this is the same as the US the software and the hardware are the same?

and I have a problem connecting with my security cameras the signal in the cameras are not good as it was on the previous mesh system I used Xiaomi mesh system and I have Imilab Wifi CAMERAS.

1 at the Kitchen 1 at the bedrooms 1 outdoor camera at the front of the house.

2 model Imilab A1 1 model Imilab ec3



The signal from what I see in the cameras show very low and they are very close to the unites. for example 1 of the camera 20 cm from the unit and it's got 56% signal the outdoor camera has just 21% signal and the bedrooms camera also not very good 38% signal.

This is not happened with my Xiaomi routers before. i want to upgrade my system and this makes a downgrade. also, I have Roborock s6 max wifi robotic vacuum cleaner and also shows a low signal.

I have 3 units of deco x60, they are new barely 3 days, what do you suggest me to do?

 and another problem is the camera does not choose the right unit, the close and keep choose the main unit there is an option to force the camera to choose the close unit and not the main.


@

TP-Link

there is any solution? thank very much for try to help me.

@XxalmogxX 

Hi, the firmware is the same for both versions but the hardware would have some limitations due to the local regulation in different countries, such as the channels(more for 5Ghz) you have mentioned earlier.

As for the signal range, I would like to follow up on your case by email, and could you please help me check the following information:

1.Except for the smart IoT devices, how about the normal network devices, like your smartphone and laptop, would they be able to get a good signal?

2.Since these smart devices mainly use 2.4ghz, if you enable the guest network for 2.4ghz only with a different SSID, will the signal get much stronger?

By the way, could you please help me run a simple test:

Put one of the satellite Deco X60 next to the main Deco, in the same spot as the Imilab cameras; then please help me check the signal source on the satellite Deco.

Thank you very much

@TP-Link 

Hii I did what u said and my network is separated the 2.4 work on Guests mode, I don't get any change if this is separate or not same result.

I put the camera next to the main unit and also put the satellite  next to the main unit the camera get 60% signal and connected to the main unit 

what is the problem I don't understand why is like that.

on the cellphones I get around 76mb on 2.4 and 150-180 on 5ghz 

I have up to 200mb DSL network.


this is some pictures from the deco app and also from the xiaomi mi home app

why the signal down  40%? how this is possible they are in the same spot and in the bedrooms camera upstires 

this is not connected also to the near unit just the main.

I have 3 floors house and that big big problem.


https://mega.nz/folder/2p5WECLA#Z6dsfrvROqC0yKTOA00osQ

@TP-Link