WDS not working between an Archer C-6 V2 and an Archer C-6 V3
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
So , I was trying to set up WDS between an Archer C-6 V3 ( as host ) and an Archer C-6 V2 , but it never seemed to work , on the C-6 V2 the WDS status was shown as ' Run ' and on the host router , it showed the the V2 router was connected. But when I connected to that network, it gave me the 'No internet' error. I tried this on both the 2.4 GHz and 5 GHz network.
The steps I followed to enable WDS were -
Logging in to the secondary router > changing the lan ip to 192.168.0.2 ( subnet of the host router ) > System tools > system parameters > enable WDS > survey > entering the password then saving > disbale DHCP Server.
I also tried restarting the router after doing that , and the WDS status was still at ' Run ' but when I connected to the network it again gave me the same ' No internet ' error.
Both the Archer C6 V2 and V3 are on the latest firmware and both are EU version.
As for the IP and gateway , the web interface shows both as 0.0.0.0 it's the same for primary and secondary DNS , and I tried pinging the gateway and it didn't work. The connection type on both the router is ' Dynamic IP '.