Home Network Community > Powerline Adapters > Can't change anything in TP-Link Utility for Mac
< Powerline Adapters

Can't change anything in TP-Link Utility for Mac

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Can't change anything in TP-Link Utility for Mac

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Can't change anything in TP-Link Utility for Mac
Can't change anything in TP-Link Utility for Mac
2021-05-16 09:07:47 - last edited 2021-07-18 16:10:36
Model: AD7200  
Hardware Version: V4
Firmware Version:

I have the Mac Utility installed and working fine. However, whenever I try to change any settings it just says 'failed' on a little popup. I'm trying to turn off the pesky Power Saving mode which is for some reason set by default. I don't have a Windows machine. What do I do?

  0      
 
  0      
 
#1
Options
1 Accepted Solution
Re:Can't change anything in TP-Link Utility for Mac-Solution
2021-05-18 01:33:52 - last edited 2021-07-18 16:10:36

@HarryBelafonte Hello, 

 

Please try the newer version 2020 tpPLC Utility for MAC,  I also updated the tpPLC Utility for macOS on the blow thread

https://community.tp-link.com/en/home/forum/topic/176086

Recommended Solution
  0  
  0  
#4
Options
3 Reply
Re:Can't change anything in TP-Link Utility for Mac
2021-05-17 09:11:52

@HarryBelafonte Hello, 

 

May I know the  macOS & Model of your MAC ?

Which tpPLC Utility do you use right now, may I know the version or have a link of the Utility you are currently using? 

For now 2020-11-19 published one is the latest one:  tpPLC_Utility_Mac 

Can you share us a photo of the Error message?  Thank you. 

  0  
  0  
#2
Options
Re:Can't change anything in TP-Link Utility for Mac
2021-05-17 15:36:35

@Solla-topee 

 

Mac Air 2020 running Catalina

 

The software version is the one linked here

 

https://community.tp-link.com/en/home/forum/topic/176086

 

The error message is just a small popup message that says 'failed' and fades after a second. Happens whenever you try to change anything

  0  
  0  
#3
Options
Re:Can't change anything in TP-Link Utility for Mac-Solution
2021-05-18 01:33:52 - last edited 2021-07-18 16:10:36

@HarryBelafonte Hello, 

 

Please try the newer version 2020 tpPLC Utility for MAC,  I also updated the tpPLC Utility for macOS on the blow thread

https://community.tp-link.com/en/home/forum/topic/176086

Recommended Solution
  0  
  0  
#4
Options

Information

Helpful: 0

Views: 10

Replies: 0

About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.