Home Network Community > Wi-Fi Routers > Can't use Ipv6 on router. Works perfectly when connected directly on ISP's modem
< Wi-Fi Routers

Can't use Ipv6 on router. Works perfectly when connected directly on ISP's modem

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Can't use Ipv6 on router. Works perfectly when connected directly on ISP's modem

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Can't use Ipv6 on router. Works perfectly when connected directly on ISP's modem
Can't use Ipv6 on router. Works perfectly when connected directly on ISP's modem
2021-02-18 15:11:15
Model: Archer C6  
Hardware Version: V2
Firmware Version: 1.1.7

I'm trying to pass my Ipv6 connectivity to my wireless router, but I can't make the Archer C6 recognize my dynamic IP. When I connect my PC via Ethernet directly to the ISP's modem, I'm able to use IPv6 normally.

However, If I connect my PC to the router's LAN ports, it appears that my router can't locate my v6 address. I've already tried setting up Dynamically and also manually, with no success.

My provider uses IPv6 with DHCPv6

Can someone help me with this?

  0      
 
  0      
 
#1
Options
1 Reply
Re:Can't use Ipv6 on router. Works perfectly when connected directly on ISP's modem
2021-02-22 03:29:50

@Diucke 


Kindly refer to the below guide to configure the IPv6 on the C6 router again:

https://www.tp-link.com/support/faq/1525/


If the connection still fails, please confirm again if the IPv6 type is Dynamic or PPPoE with your ISP. BTW, who is your ISP?


What is your network topology, is it ISP modem--C6? Is the IPv4 connection on the C6 good or not? What is the WAN IP address of it?

  0  
  0  
#2
Options

Information

Helpful: 0

Views: 3

Replies: 0

About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.