@AleP 

Hi,

Thank you very much for your kind feedback.

I have reported to the senior engineers already for a better solution.

At the same time, have you had to manually set up the static IP address and configure the router’s LAN IP address as the gateway?

Thanks a lot and wait for your reply.

@TP-Link 

Hello,

I've tried to configure the static IP on the repeater, using the router IP as the default gateway.

But the client connected to the powerline via WI-FI is getting the correct IP (the same that router assign) and the wrong Gateway (the powerline IP)

for example:

Router's IP 192.168.0.1

Powerline:

IP 192.168.0.100 (static)

Default Gateway 192.168.0.1

Device:

IP 192.168.0.101

Default Gateway 192.168.0.100

And the device cannot reach internet.

Hello all,

same issue here as many devices in the past. It would help to be able to turn off DHCP server on these devices.

I ve read people installing custom firmware to do so.

Please advise.

Kind regards,

Niko

@nstnst Hi Nico, 

May I know the hardware version & model number of your powerline device, do you also use TL-WPA8631P ( EU ) V3?  Please help check on the sticker, thank you.

@Solla-topee 
hey are there any firmware betas for the WPA8631P to turn of the DHCP to prevent the error?
I hhave the V3 EU Version.

I saw in a another thread for the WPA8630P that there was a beta firmware i hope you could provide one for the new WPA8631P too
Thank you

@Tilli Hello, 

I sent you a beta firmware via private message, you could click on your profile to check the message~