Home Network Community > Deco > Deco S4 - Solid Red light
< Deco

Deco S4 - Solid Red light

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Deco S4 - Solid Red light

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Deco S4 - Solid Red light
Deco S4 - Solid Red light
2020-12-15 20:31:11
Model: Deco S4  
Hardware Version:
Firmware Version:

HI,

 

I've just installed the Units for someone and after the Firmware update one of the Unit lost connection.

I tried resetting it but its always Red light.

I think it might be bricked and I tried following the instructions to connect  it to PC and then upload the firmware manually but I cannot get it to flash yellow.

 

when connected to PC, no light comes on the unit itself after the power LED goes off.

  0      
 
  0      
 
#1
Options
4 Reply
Re:Deco S4 - Solid Red light
2020-12-16 08:47:07

@StarLordGroot 

Hi,

When you reset the Deco  S4, would you notice the solid red become flashing yellow, or any LED change?

If possible, please also try to do firmware recovery based on the following link:

https://www.tp-link.com/support/faq/2958/

Deco S4 used HTTP Uboot Method as well.

Thank you very much.

  0  
  0  
#3
Options
Re:Deco S4 - Solid Red light
2020-12-16 19:11:07

@TP-Link 

 

TP-Link wrote

@StarLordGroot 

Hi,

When you reset the Deco  S4, would you notice the solid red become flashing yellow, or any LED change?

If possible, please also try to do firmware recovery based on the following link:

https://www.tp-link.com/support/faq/2958/

Deco S4 used HTTP Uboot Method as well.

Thank you very much.

No LED change after reset, solid red. tried multiple times

I've returned the whole set and ordered replacement which arrived today, so set that up and sent the broken one back.

 

all working now.

  0  
  0  
#4
Options
Re:Deco S4 - Solid Red light
2021-04-05 03:29:40

@StarLordGroot I have the exact same issue. lost connection while testing two of my three nodes and now I get red light even after doing full reset hooked up to the PC. 

  0  
  0  
#5
Options
Re:Deco S4 - Solid Red light
2021-04-06 03:46:35

@AK1111 

Hi, When you reset the Deco, was there any change on the LED lights, or it was red all the time?

And have you tried the firmware recovery here on this link:

https://www.tp-link.com/en/support/faq/2958/

Thank you.

  0  
  0  
#6
Options

Information

Helpful: 0

Views: 11

Replies: 0

About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.