Home Network Community > Wi-Fi Routers > Wired connection doesn't work with tplink ac1200 archer c6
< Wi-Fi Routers

Wired connection doesn't work with tplink ac1200 archer c6

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Wired connection doesn't work with tplink ac1200 archer c6

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Wired connection doesn't work with tplink ac1200 archer c6
Wired connection doesn't work with tplink ac1200 archer c6
2020-12-06 19:48:20 - last edited 2020-12-07 07:57:10
Model: Archer A2  
Hardware Version: V2
Firmware Version:

For some reason, I can't access the control panel via wired connection but only if I connect to the router WiFi https://www.tp-link.com/us/home-networking/wifi-router/archer-c6/ (I've just have powered on and connected my pc to ETH1 to see if I was able to access 192.168.0.1 but I can only access it via Wifi)

[I chooses a random Model because I can't find the right one]

  0      
 
  0      
 
#1
Options
1 Accepted Solution
Re:Wired connection doesn't work with tplink ac1200 archer c6-Solution
2020-12-07 07:56:56 - last edited 2020-12-07 07:57:10

@NicoC the issue was I had my network card with a static IP that wasn't ok with the router. I switched to dynamic IP on the card and now works also via wire

Recommended Solution
  0  
  0  
#4
Options
3 Reply
Re:Wired connection doesn't work with tplink ac1200 archer c6
2020-12-06 23:16:20 - last edited 2020-12-06 23:17:52

@NicoC 

 

Follow this guide. Then turn off your computer's wi-fi and connect by ethernet cable to the router LAN port.

Start a browser and open the IP address you discovered when following the guide above.

  0  
  0  
#2
Options
Re:Wired connection doesn't work with tplink ac1200 archer c6
2020-12-07 06:51:51

@Ivaylo 

 

I've already done that as, to access via WiFi it needs the router IP (which is 192.188.0.1 )

 

Problem is that if I'm connected via ethernet instead of WiFi it says it can't be reached

  0  
  0  
#3
Options
Re:Wired connection doesn't work with tplink ac1200 archer c6-Solution
2020-12-07 07:56:56 - last edited 2020-12-07 07:57:10

@NicoC the issue was I had my network card with a static IP that wasn't ok with the router. I switched to dynamic IP on the card and now works also via wire

Recommended Solution
  0  
  0  
#4
Options

Information

Helpful: 0

Views: 7

Replies: 0

About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.