AV600 only gets 100 mbps from router
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.AV600 only gets 100 mbps from router
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I've installed the AV600 kit with TL-WPA4220 (V3 fw 3.0.3) as wifi extender and TL-PA4010 (it say V2 on the back) as router connecter.
The connection works but I'm not getting speeds higher than 60 Mbps. In my router webpage I can see that it the TL-PA4010 device is in the 100 Mpbs mode. In order to reach the advertised 300 Mbps wifi speed I guess the mode should be 1000 Mbps.
It's not the router, nor the cable, because when I connect the same cable directly to my laptop with gigabit ethernet I can see in the routers webpage that it's on 1000 Mbps mode and a speedtest results in 300 Mbps speed. My contract with my ISP is 500 Mbps max.
How can I get the powerline to function in gigabit mode?
I'm not a network specialist, so if i'm wrong about some of the points above, please let me know.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
The PA7017 will operate at slower powerline AV500/600 speeds of your slower adapters.
Unless you are already getting close to 100 Mbps over wifi from your WPA4220, I doubt you will get any further improvement by installing PA7017 wired to your gigabit router.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 25
Replies: 0
Voters 0
No one has voted for it yet.