@GSV-CargoCult Having the same problem, we have been changing the date and time and then run the quick setup to get it running again. Tried updating firmware, even tried rolling it back. No joy, it does it again the next day. Any help would be appreciated

@Kyndahl @GSV-CargoCult 

Good day.

Thank you very much for your time and patience.

For your case, we would like to forward your case to the senior engineers for further assistance.

At the same time, please help us get the following information:

1. The hardware and firmware version of Archer VR2100;
2. Where are you located and who is your internet service provider?

Thanks a lot.

@GSV-CargoCult

Thankyou @Sunshine 

I'm an Aussie,

so NSW Australia

isp is Superloop 

and current device info is 

Firmware Version: 1.1.0 0.9.1 v009e.0 Build 200116 Rel.60756n

Hardware Version: Archer VR2100 v1 00000000

We had rolled the firmware back using a file available on your website, build 191218.

No luck with that, so we updated to the current again.

I have a couple of logs saved if you need them.

Thank you for your time

K

@Kyndahl 

Good day.

Thank you very much for your quick reply.

 Please refer to your email and install the debug firmware and help us get the debug.log;

Thank you very much for your time and patience.

@Sunshine .  I'll give the debug firmware a go tonight

My ISP is Plusnet_VDSL and I am based in the UK.  Hardware/firmware versions in my initial post