TL-SG1016D 16-Port Gigabit Ethernet Switch
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
TL-SG1016D 16-Port Gigabit Ethernet Switch
Just got a replacement TL-SG1016D 16-Port Gigabit Ethernet Switch, to replace the EXACT same model of these switches that failed after about 4 months.
I've Just plugged the new one in and although the corresponding lights blink, I am unable to connect (to the internet) ANY of the TEN devices, (physically) connected to the switch.
Doing a simple "swap out" with another "switch" confirms all the connections/cables are OK, I simply have more devices, than the working switch can handle?
I don't think these is are any configuration issues involved as the switch is unmanaged. Power is ok as the unit "blinks"
This is the 3rd switch (same model) I have now had in the past 18 months. I can't believe the failure rate is so high ?
Is there anything else I can try ?
Good day,
Thank you very much for your time and patience.
Sorry for the delay.
Could you please help me check the IP address and default gateway when the clients are connected behind the TL-SG1016D?
If possible, please also help us run a ping test, such as:
https://www.tp-link.com/support/faq/738/
By the way, where are you located and where did you purchase these switches?
Thanks a lot.