Tapo C200 not working after firmware update to 1.0.14
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
slightly at a loss here. I have 16 tapo C200's. I updated all of them earlier today to firmware 1.0.14
13 of them rebooted just fine and are working.
3 of them didn't and the LED is off - doesn't flash red or anything. The 4 night vision lights by the side are on though.
1. Unplugging and plugging it back in doesn't work
2. factory reset doesn't work - I don't get the audio message and it doesn't seem to do anything.
3. Tried plugging those 3 in to different power adapters. That doesn't work either
4. Took out the SD cards and tried all 3 methods above - doesn't work either.
They were all fine up to the point of the firmware update. Any ideas? thanks in advance
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
@max83 Thanks for the further information, you could try to contact local support Hotline or Email to check warranty with the forum information:
https://www.tp-link.com/support/contact-technical-support/#Hotline-Support
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 49
Replies: 0
Voters 0
No one has voted for it yet.