Home Network Community > 3G/4G Routers/MiFi > Interface problem
< 3G/4G Routers/MiFi

Interface problem

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Interface problem

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Interface problem
Interface problem
2020-08-26 07:27:34 - last edited 2020-09-09 02:15:39
Model: Archer MR200  
Hardware Version: V3
Firmware Version: 1.3.0 0.9.1 v0001.0 Build 180702 Rel.71921n / 1.9.0.0.9.1 v0001.0 Build 190307 Rel.54196n

Dear Sir/Madam

 Hello i'm sujit pandit. Before few a days i'm using this model it's good now i'm facing problem. The problem are 

 < At the interfacing with lan port.

 < VLAN ID not there then also showing this 

 i changed firmwere then also i faced same problem. Below picture is here what i was phased the peoblem. 

Thank you.

  0      
 
  0      
 
#1
Options
1 Accepted Solution
Re:Interface problem-Solution
2020-09-09 02:14:57 - last edited 2020-09-09 02:15:39

@sujitpandit 

Good day.

Sorry for the delay.

Just want to be sure, even after reset, and choose the wireless router mode again, the same error message would still be here, right?

Is the router given by your internet service provider?

And is the first that you set up the MR200 as a wireless router with the fiber connection?

Later, we would like to follow up your case via email and please have a check of your email box.

Thank you very much.

Recommended Solution
  0  
  0  
#4
Options
3 Reply
Re:Interface problem
2020-08-28 01:48:10

@sujitpandit 

Good day.

Have you changed the operating mode to wireless router mode, instead of 3/4G router mode?

And if you reset the Archer MR200 and set it up again , would you have the same issue?

Thank you very much.

  0  
  0  
#2
Options
Re:Interface problem
2020-08-31 05:51:48

@Sunshine 

 yes i changed router mode. then also same problem. if i select 3G/4G it's ok but i have fiber connection so i changed as router mode.

  0  
  0  
#3
Options
Re:Interface problem-Solution
2020-09-09 02:14:57 - last edited 2020-09-09 02:15:39

@sujitpandit 

Good day.

Sorry for the delay.

Just want to be sure, even after reset, and choose the wireless router mode again, the same error message would still be here, right?

Is the router given by your internet service provider?

And is the first that you set up the MR200 as a wireless router with the fiber connection?

Later, we would like to follow up your case via email and please have a check of your email box.

Thank you very much.

Recommended Solution
  0  
  0  
#4
Options

Information

Helpful: 0

Views: 10

Replies: 0

About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.