How to Configure WAN PPPoE in Access Point (AP) mode of TL-MR3020 (EU) v3.20?
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
When in Access Point (AP) mode, the Network section of the router's web-based admin console at http://tplinkwifi.net/ doesn't provide an option to set the connection type to PPPoE & provide the relevant username & password. Then how to set up PPPoE in AP mode?
NOTE: The admin console DOES allow setting connection type to PPPoE in WISP mode but my requirement is PPPoE in AP mode.
Following are the Quick Setup screens:
I found the solution thanks to this reply. Switch the router to 3G/4G mode, & perform Quick Setup at http://tplinkwifi.net/ as shown below:
If your ISP has captured your MAC, either call them up & provide this router's new MAC or configure this router to use the MAC that's already whitelisted at the ISP, as shown below (see bottom of pic):
I found the solution thanks to this reply. Switch the router to 3G/4G mode, & perform Quick Setup at http://tplinkwifi.net/ as shown below:
If your ISP has captured your MAC, either call them up & provide this router's new MAC or configure this router to use the MAC that's already whitelisted at the ISP, as shown below (see bottom of pic):